11
Apr

How to Install a Wireless Home Alarm System

Published: Apr 11, 2014 at 21:00 UTC
How to Install a Wireless Home Alarm System

There are numerous reasons why a wireless home alarm system is the top choice of people these days, but its ease of installation is perhaps the biggest one.

With gradual technological development, the option of wired security systems was replaced by even a better choice in the form of a wireless home alarm system. Even though traditional wired security systems were effective in providing security to a home, there were too many problems associated with them to make them a good choice for a household. Holes had to be drilled throughout the house for running the wires and electricians and carpenters had to be hired for doing this job. This was immensely expensive and the entire system would depend on the house’s power grid, which means it would be useless in a power outage. The beauty of a wireless home alarm system is that it can be installed by the homeowners themselves.

Sensor Locations:

The first thing that people should do is walk around the house for identifying all the places that might be vulnerable to a break in by an intruder. It has been substantiated through statistics that the number one target in burglaries is doors so it is essential that sensors be placed on all the exterior doors of the house. Windows is another area that’s also prone to a break in. As there are several windows in a home, it might be a bit too costly for people to place a sensor on each one. As an alternative, people can opt to place a motion sensor in all rooms so an alarm will be sent to the control panel if anyone attempts to come through a window.

Door Sensors:

There is a limited range of the wireless transmitters inside the sensors. Before any remote sensors are installed, people should check their operation by standing at the intended position to ensure they are working properly even when at a distance from the control panel. Two pieces are part of a door sensor; a wireless transmitter is the larger half and a magnet completing the circuit is the smaller half. The circuit is broken when the door is opened and this will trigger the alarm. The sensors should be secured to the door jamb with the help of screws.

Motion Sensors:

A wireless home alarm system also provides support for motion sensors that work by sensing changes in temperature. These sensors should not be pointed towards the windows because the temperature of the glass changes according to cold and hot periods. Although infrared technology is used by these sensors for detecting body heat, the sensor will not be affected by pets as long as the sensitivity is adjusted. A motion detector should be installed at a place that offers an unobstructed view of the entire room.

Control Panel:

The control panel of a wireless home alarm system needs to be programmed after all the sensors have been installed. The controller should be plugged into an electrical outlet and a phone jack. The programming procedure of the system should be followed carefully as the entire sequence will have to be repeated in case of a mistake. Once the system has been programmed, it will sound of an alarm on the activation of the sensor. Then, the wireless home alarm system will alert the homeowners or the proper authorities, depending on the programming.

 
No Comments
Add your comment

Leave a Reply